Differences

This shows you the differences between two versions of the page.

--- builderpages:plasmo:zz80mb:zz80mbr3 [2020/11/28 09:34]
plasmo
+++ builderpages:plasmo:zz80mb:zz80mbr3 [2020/12/05 21:29] (current)
plasmo
@@ Line 31: / Line 31: @@
 {{:builderpages:plasmo:zz80mb:zz80mbr3:zz80mb_rev3_gerber.zip|Gerber photo plots}}
-Bill of materials
+{{:builderpages:plasmo:zz80mb:zz80mbr3:zz80mb_rev3_bom.pdf|Bill of materials}}
 ==== Software ====
@@ Line 41: / Line 41: @@
 {{:builderpages:plasmo:zz80mb:zz80mbr2:progsst39f040_v0_1_release.zip|SST39F040 programmer, rev 0.1}}. This is the SST39F040 programmer. ZZ80MB is set to 'RAM' and 'Serial' bootstrap jumper positions. The terminal is set to 115200 odd parity. The serial bootstrap loader is loader first followed by progSST39F040. Issue the command 'G8000' (←'G' is upper case, '8000' will not echo back) to invoke progSST39F040. The program will prompt the user to erase SST39F040 and then load the hex file to be programmed.
-{{:builderpages:plasmo:zz80mb:zz80mbr2:zz80monitor_rev0_3_fix_b3_c3.zip|ZZ80MB Monitor rev 0.3}}  This is the program to be burn in the flash memory. Once EPROM is programmed, set the serial port to 115200, no parity, 8-data, 1-stop and set the jumpers on ZZ80MB to “EPROM” position and Bootstrap to “EPROM” position. This is the setting for normal operation.
+{{:builderpages:plasmo:zz80mb:zz80mbr3:zz80monitor_rev0_5.zip|ZZ80MB Monitor rev 0.5}}  This is the program to be burn in the flash memory. Once EPROM is programmed, set the serial port to 115200, no parity, 8-data, 1-stop and set the jumpers on ZZ80MB to “EPROM” position and Bootstrap to “EPROM” position. This is the setting for normal operation.
 {{:builderpages:plasmo:zz80mb:zz80mbr2:zz80rc_r1_cf_at_0x10_4_cfdrives.zip|CP/M2.2 BIOS/BDOS/CCP }}  CP/M2.2 executable tailored for ZZ80MB. It is loaded into memory with ZZ80CFMon, then use '**c2**' command to store it in CF disk and use '**b2**' command to boot into CP/M2.2.