Differences

This shows you the differences between two versions of the page.

--- builderpages:plasmo:simple80r1 [2020/09/28 22:48]
plasmo
+++ builderpages:plasmo:simple80r1 [2023/01/28 21:57] (current)
plasmo
@@ Line 13: / Line 13: @@
   * 128K RAM
   * 64K PROM or EEPROM
+  * CP/M 2.2 and CP/M 3
   * Three classic RC2014 expansion connectors
   * 100mm X 100mm pc board
@@ Line 33: / Line 34: @@
 ==== Software ====
-{{:builderpages:plasmo:simple80:simple80_rev1pcb_simple80mon_v0_6.zip|Simple80 Monitor}}  rev0.6, a basic monitor for Simple80. Use this monitor to initialize CF disk and load CP/M2.2 BIOS/CCP/BDOS.
+Simple80 rev1 is software compatible with Simple80. Please see [[:builderpages:plasmo:simple80#software|Software section of Simple80]].
-{{:builderpages:plasmo:simple80:scmonitor_simple80_startrek.hex|SCMonitor for Simple80}}. This is Steve Cousin's SCMonitor ported to Simple80. Startrek program is included in this port. To run Startrek, type 'wbasic' followed by 'run'.
-{{:builderpages:plasmo:simple80:simple80_cpm22_release.zip|CP/M2.2 for Simple80}}. This is the BIOS/CCP/BDOS ported to Simple80.
-{{:builderpages:plasmo:simple80:simple80_cpm:xmodem.hex|XMODEM.hex}}, this is the xmodem file transfer program in Intel Hex format.
-{{:builderpages:plasmo:simple80:simple80_cpm:cpm22_unarj.zip|CPM22_unarj}}, this zipped file contains two files: cpm22dri.arj is compressed CP/M2.2 distribution files; and unarj.com is file needed to decompress dpm22dri.arj. These two files need to be loaded into CF disk use xmodem.
 ===== Manuals =====
-[[:builderpages:plasmo:simple80:getting_started|Getting started with Simple80]]. This is the instruction for installing software in Simple80.
+[[:builderpages:plasmo:simple80:assembly_simple80r1_2|Pictorial assembly guide]] for Simple80, rev1.2