Differences

This shows you the differences between two versions of the page.

--- builderpages:plasmo:rr512k:rr512k_rev1 [2020/09/27 09:54]
plasmo
+++ builderpages:plasmo:rr512k:rr512k_rev1 [2020/12/12 10:11] (current)
plasmo
@@ Line 23: / Line 23: @@
 Gerber {{:builderpages:plasmo:rr512k:rr512k_rev1:rr512k_rev1_gerber.zip|photoplot}}
-{{:builderpages:plasmo:rr512k:rr512k_rev1:rr512k_rev1_cpld.zip|CPLD equations}}
+{{:builderpages:plasmo:rr512k:rr512k_rev1:rr512k_rev1pcb_cpld_release_with_i2c.zip|CPLD equations }}  <-updated CPLD with I2C interface
 Bill of Materials
+[[:builderpages:plasmo:rr512k:rr512k_rev1:ec_i2c|Engineering change]] to enable I2C interface and CTS handshake
+==== Software ====
+ROMWBW, this board is designed to run Wayne Warthen's excellent ROMWBW. The binary of {{:builderpages:plasmo:rr512k:rr512k_rev1:romwbw191_bin.zip|ROMWBW v1.9.1}}  is provided here for convinience. The homepage for ROMWBW is located in [[https://github.com/wwarthen/RomWBW|GitHub]].
+{{:builderpages:plasmo:rr512k:rr512k_rev1:rrmon_v0_2_rr512k_rev1.zip|RRMon rev 0.2}}, this is separate monitor for this board loaded via serial bootstrap software. Its purpose is board diagnostic. The monitor is under development and subject to changes.
+==== Jumper Configuration ====
+[[https://www.retrobrewcomputers.org/lib/exe/fetch.php?tok=af47cd&media=https://www.retrobrewcomputers.org/lib/plugins/ckgedit/fckeditor/userfiles/image/builderpages/plasmo/rr512k/rr512k_rev1/rr512k_r1_jumpers.jpg|{{https://www.retrobrewcomputers.org/lib/plugins/ckgedit/fckeditor/userfiles/image/builderpages/plasmo/rr512k/rr512k_rev1/rr512k_r1_jumpers.jpg?direct&400x256|www.retrobrewcomputers.org_lib_plugins_ckgedit_fckeditor_userfiles_image_builderpages_plasmo_rr512k_rr512k_rev1_rr512k_r1_jumpers.jpg}}]]
 ===== Applications =====
@@ Line 61: / Line 73: @@
 Programming is completed when 'X' is output. It takes about 2 minutes to program 512K EPROM.
+==== I2C Interface ====
+[[:builderpages:plasmo:rr512k:rr512k_rev1:ec_i2c|Engineering change]] to add 4-pin I2C connector to interface to 128×64 OLED display
+===== To Do =====
+Developing additional functions in CPLD utilizing the spare I/O pins:
+  * SPI
+  * WB2812B interface to drive array of RGB LEDs
+==== Rev1.1 wish list ====
+  * Add RTS handshake
+  * Add IDE interface for disk-on-module
+  * Move jumpers to more convenient locations
+  * Add interface to I2C, SPI, and WB2812B
+  * optional reset supervisor