Differences

This shows you the differences between two versions of the page.

--- builderpages:plasmo:68340:sbc68340r0:sbc68340r0home [2025/04/01 20:43]
plasmo
+++ builderpages:plasmo:68340:sbc68340r0:sbc68340r0home [2025/04/04 22:59] (current)
plasmo
@@ Line 23: / Line 23: @@
 {{:builderpages:plasmo:68340:sbc68340r0:340bug_v03.zip|340Bug monitor v0.3}}, still under construction to remove redundant functions
-{{:builderpages:plasmo:68340:sbc68340r0:tutor_v1_3_mod_for_sbc68340.zip|Tutor v1.3}}  for Easy68K <- the original Tutor modified to use Easy68K's Trap15 services.  type "go 44000" in 340Bug to invoke Tutor
+{{:builderpages:plasmo:68340:sbc68340r0:tutor_v1_3_mod_for_sbc68340.zip|Tutor v1.3}}  for Easy68K <- the original Tutor modified to use Easy68K's Trap15 services. type "go 44000" in 340Bug to invoke Tutor
+CP/M demo.  This {{:builderpages:plasmo:68340:sbc68340r0:340bug_cpm15000_bios340_flash_drive.zip|flash programming file}}  contains 4 components; 340Bug monitor, CPM15000, BIOS340, and a small flash disk.  Start CP/M68K with 'bo' command in 340bug monitor.  There are two drives: drive A is flash drive with 3 files, init, pip, and stat; drive B is 64K RAM drive.
+{{:builderpages:plasmo:68340:sbc68340r0:source_340bug_bios340_drivea_32k_cpm1500.zip|Source files}}  for above CP/M demo
+{{:builderpages:plasmo:68340:sbc68340r0:gkermit_for_driveb.zip|Gkermit for drive B}}.  Load this s-record before issuing 'bo' command.  Gkermit.68K will show up in drive B.  <-note, gkermit won't work at 115200 baud.  The serial clock should be 614400hz to enable 38.4K baud serial communication to run gkermit file transfer.
 ----