I will study a little Kicad schematics because I never use it before..
I just want to have 2/3 Cards at the end and as far as they measure 16*10cm (I will have around 30/35 cm long board).
I admit that I need to read more stuff :-)
Thank's for your response Edward.
Le mercredi 1 octobre 2014 15:13:10 UTC+2, Edward Snider a écrit :
I suppose you could use a 90 degree male connector, but you'd end up with a really long package,
or block slots. However, this is a single board computer, so if you used something like this (
PPIDE)
for storage, you wouldn't even need the backplane (using the serial port for a console).
-Ed
On Wednesday, October 1, 2014 4:29:07 AM UTC-5, Neslou wrote:
Hi All,
Is it always possible to buy Some N8VEM SBC V2 ? (2 or 3)
Also, I have some question ? Is it possible to make ECB connector in Right Angle type? I mean I would like to use a little case not like the ECB Backplane but more of a desktop format..
Regards.
Neslou.