Hi James! I finally have v1.08 operational of the Multicomp Interface PCB and I was wondering how you are getting 5V to the 2.4” TFT LCD display or can it run off 3V? I can’t seem to find a 5V power supply readily available. The nearest voltages I find are 4.5V or 6V. I’m currently using a 6V power supply. I’d like to have a LM7805 on the PCB to run the LCD screen, but there is no space. I’m not sure how to determine the inside and outside diameters of DC power jacks to buy one off ebay. I don’t remember the parameters of the one I used. Are there any helps available along these lines? Any ideas? Thanks in advance! |