[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Problem with parts

To: n8vem@googlegroups.com
Subject: Re: Problem with parts
From: Wayne Warthen <wwar...@gmail.com>
Date: Sun, 10 Feb 2013 08:48:58 -0800 (PST)
In-reply-to: <afffc94f-b6aa-49d3-a9de-444c8102690a@googlegroups.com>
References: <8fb14ec6-be18-4d83-8f79-fedd39a369fe@googlegroups.com> <afffc94f-b6aa-49d3-a9de-444c8102690a@googlegroups.com>

Hi Martin,

Yes, the 24C512 does need to be programmed. The good news is that it can be programmed in-situ on the board using the serial port.

Assuming you are using the RomWBW firmware on your Zeta board, then just refer to the instructions in the "Propeller ROM" section of the ParPortProp documentation file here: http://n8vem-sbc.pbworks.com/w/page/52472959/ParPortProp

A pre-built copy of the firmware is found in the "Support\ParPortProp" subdirectory of the RomWBW distribution zip file.

Thanks,

Wayne

On Sunday, February 10, 2013 5:42:54 AM UTC-8, Martin Boháč wrote:

Hi !
I ve got problem with PropIO board . If i understand the 24C512 is EEPROM .And there start my problem . Is there any program what i must burn into them ?

References:
- Re: Problem with parts
  - From: Martin Boháč <bohacm...@gmail.com>

Prev by Date: Re: Problem with parts
Next by Date: Re: Problem with parts
Previous by thread: Re: Problem with parts
Next by thread: Re: Problem with parts
Index(es):
- Date
- Thread