-Wayne
On Thursday, July 26, 2012 7:15:24 PM UTC-7, Doug Wood wrote:
Sergey , Wayne,
Case Solved !!!
I must have a Horseshoe in the right place tonight.
I replaced the 82c55 with the one i had in the N8VEM SBC and Then the board Booted Sucessfully !!!!!!!!!! Yahoo !!!
Sure is my lucky night.
Thanks for the help guys
Doug Wood
On Thursday, 26 July 2012 21:30:31 UTC-4, Doug Wood wrote:Sergey,
I haven't tested the parallel port. Ill load the non PPP
firmware and run the test utility.
I'm trying to figure out from the display i get on my screen whether i'm looking at a
software or hardware problem. I have a CF/ide Board but not a PPIDE Board.
Ill Start with the test Utility.
Thanks
Doug
On Thursday, 26 July 2012 19:35:02 UTC-4, Sergey wrote:Well, that should be working. For test purposes, can you load a non-
ppp version and run the test utility?
Also have you tested the parallel interface with any other devices
(e.g. PPIDE)?
Thanks,
Sergey
On Jul 26, 4:20 pm, Doug Wood <whitb...@gmail.com> wrote:
> Sergey
>
> I am Using the RomWBW 2.0
> For the Zeta Rom Im Using Zeta_ppp.rom on the 39sf040
>
> For the PPP im Using ParPortProp.eeprom on the 24lc512
>
> Doug
>
>
>
>
>
>
>
> On Thursday, 26 July 2012 18:27:47 UTC-4, Doug Wood wrote:
>
> > Hi Everyone,
> > I turned on my PPP last night for the first time.
> > Everything seemed to initialize okay and a banner Acress the Bottom.
>
> > Init ParPortProp .....ok
> > Init Keyboard ......ok
> > Init SD Card .......ok
> > Init Serial Port .......ok
> > Starting PortIO cog ...ok
>
> > Banner Across The Bottom Of the screen.
> > Flashing cursor
> > The problem is there is no keyboard input.
> > I tried two different keyboards. ( no Change )
>
> > I used the files specified by Surgey for the ZETA SBC and the PPP Board
> > eeprom.
>
> > Checked jumpers on both Boards. Par port to Par Port IDC 26 pin cable
> > seemp ok.
> > My Zeta SBC has been working for 2 months with no apparent problems.
> > Does anyone have any suggestions ?
>
> > Thanks
>
> > Doug Wood