RetroBrew Computers Forum: General Discussion » VGA3 warbled text with MSDOS setup disk

Home » RBC Forums » General Discussion » VGA3 warbled text with MSDOS setup disk (Incorrect characters on VGA monitor )

Show: Today's Messages :: Show Polls :: Message Navigator

VGA3 warbled text with MSDOS setup disk [message #10030]

Tue, 26 July 2022 00:27

microbit
Messages: 18
Registered: June 2022
Location: Melbourne

Junior Member

I'm hoping this constitutes a known problem someone can help with.

I just built and fired up a VGA3 board driven by SBC-188
on a 4 board ECB.
Everything works great, except that when I try to install
To a fresh drive (CF on IDE adapter), the installation prompts appear as gobbledigook.
The bottom line of the screen appears correct though, while it's eg. showing the current MSDOS file being read/written.

This happens with both the MSDIS 5.00 and 6.22 setup floppies. These floppies work fine when I'm installing using ANSI terminal BIOS instead of VGA3.

Any help/pointers would be much appreciated.
I'm attaching an example screenshot.

TIA

Attachment: 20220726_164609.jpg
(Size: 3.17MB, Downloaded 139 times)

Report message to a moderator

Re: VGA3 warbled text with MSDOS setup disk [message #10031 is a reply to message #10030]

Tue, 26 July 2022 21:01

microbit
Messages: 18
Registered: June 2022
Location: Melbourne

Junior Member

As an update (for the lurkers Smile

, I just put the ANSI terminal BIOS
back in, installed 6.22 with that (obviously the "scrolling" text in top install screen is encoded in a way the ANSI trans can work out but not the VGA3 BIOS), and then went back to VGA3 BIOS.
Works fine now, still wonder what the story is...

Report message to a moderator

Previous Topic:	Building an Apollo Guidance Computer
Next Topic:	No ALT function on MSDOS 6.22 EDIT screen

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Mar 19 03:00:36 PDT 2025

Total time taken to generate the page: 0.00610 seconds