RetroBrew Computers Forum: General Discussion » replacing vintage CPU with MCU emulation

Home » RBC Forums » General Discussion » replacing vintage CPU with MCU emulation

Show: Today's Messages :: Show Polls :: Message Navigator

replacing vintage CPU with MCU emulation [message #9902]

Fri, 06 May 2022 06:55

lynchaj
Messages: 1080
Registered: June 2016

Senior Member

Hi
This is just a thought experiment. I was wondering if it would be possible to replace a vintage CPU like a Z80 with an MCU based emulation board.

What I mean by emulation is a cycle-exact replacement of a vintage CPU with an MCU based board in the existing socket such that any legacy software would run unaffected.

For instance, build a modern ARM MCU board with a 40 pin socket interface that can be swapped out for an actual Z80 and everything would continue as before.

Sort of a local ICE board but small enough to fit on the main board without ribbon cables, etc.

I have seen 6502 replacements using FPGAs so this is kind of similar but using a modern MCU instead.

Thanks, Andrew Lynch

Report message to a moderator

Re: replacing vintage CPU with MCU emulation [message #9903 is a reply to message #9902]

Fri, 06 May 2022 08:45

e2k
Messages: 33
Registered: June 2021

Member

It has been made for a 68000:

https://www.buffee.ca/

you can see a picture here:

https://amitopia.com/buffee-is-real-and-tf1200-is-coming/

Report message to a moderator

Re: replacing vintage CPU with MCU emulation [message #9904 is a reply to message #9902]

Sat, 07 May 2022 04:48

will
Messages: 213
Registered: October 2015

Senior Member

Another similar project for the Amiga is PiStorm which is a 68000-pin compatible board that uses 68K emulator software on a raspberry pi to replace the CPU, as well as adding fast RAM, virtual SCSI and graphics hardware using the pi's onboard resources. There's at least a couple of different soft-68K cores the project can use -- one is the Musashi 68K which works as an interpreter and gives CPU performance equivalent to a 100--125MHz 68030 (23,000 Dhrystones, 24 MIPS). A second is Emu68 which is a 68K to ARM just-in-time (JIT) compiler which is ... much faster (795,000 Dhrystones, 830 MIPS).

Report message to a moderator

Re: replacing vintage CPU with MCU emulation [message #9905 is a reply to message #9904]

Sat, 07 May 2022 09:16

scruss
Messages: 62
Registered: December 2015
Location: Toronto, Canada

Member

This isn't exactly pin-for-pin compatible, but the PiTubeDirect emulates processors/RAM at the end of the BBC Micro's 2 MHz "Tube" bus. The range of processors is pretty impressive, and they all run bare-metal on a Raspberry Pi.

These leaves one with the considerable problem of actually getting a Raspberry Pi, though ...

> Does anyone know what each of the pins on the 6502 CPU chip in the Apple II Plus does?
They all plug into the socket on the motherboard to keep the chip from drifting away. - c.s.a2 FAQ of yore

Report message to a moderator

Previous Topic:	Favorite sources for vintage IC chips
Next Topic:	Replacing my old hand-wired 65C02 card with a custom PCB

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Mar 19 01:48:58 PDT 2025

Total time taken to generate the page: 0.00743 seconds