| Re: Zeta 2 and ParPortProp [message #9653 is a reply to message #9646] |
Fri, 21 January 2022 01:09  |
stefanf
Messages: 4
Registered: October 2021
|
Junior Member |
|
|
Hi there,
Thanks for the feedback. Whether I plug jumper 1 or not, the behavior is the same.
This message appears on the external monitor connected to the ParPortPorp Board:
Initializing ParPortProb .... OK
Initializing Keyboard....OK
Initializing SD card..... OK
Initializing Serial Port... OK
Starting PortIO cog..... OK
ParPortProp is ready!
and when I connected a PC with terminal software to the RS232 of the ZETA 2 board, these messages:
RomWBW HBIOS v3.0.1, 2020-04-04
ZETA V2 Z80 @ 8,000MHz
0 MEM W/S, 1 I/O W/S, INT MODE 2
512KB ROM, 512KB RAM
CTC: MODE=Z2 IO=0x20
UART0: IO=0x68 16550A MODE=38400,8,N,1
DSRTC: MODE=STD IO=0x70 Wed 2022-01-19 19:40:37 CHARGE=OFF
MD: UNITS=2 ROMDISK=384KB RAMDISK=384KB
The ParPortProb Board is shown as not connected with the address 0X60, although it is connected.
I didn't connect a chain drive because I still don't have the chip for it.
greeting
Stefan
|
|
|
|
RetroBrew Computers Forum
Members
Search
Help
Login
Home
