RetroBrew Computers Forum: General Discussion

Home » RBC Forums » General Discussion » Zeta 2 and ParPortProp

Show: Today's Messages :: Show Polls :: Message Navigator

Re: Zeta 2 and ParPortProp [message #9646 is a reply to message #9640]

Thu, 20 January 2022 10:24

alkmar
Messages: 29
Registered: August 2019

Junior Member

Can you confirm that JP1 on the Zeta 2 PCB does NOT have a jumper installed? If this is shorted all console output will be directed to the Zeta 2 serial port.

If JP1 is open all output will be directed to your ParaPortProp (VGA output and DIN keyboard input).

When booting the computer without the ParaPortProp attached, do you get all of the output I listed previously (aside from missing the devices related to the ParaPortProp)?

[Updated on: Thu, 20 January 2022 11:40]

Report message to a moderator

[Message index]

		Zeta 2 and ParPortProp By: stefanf on Tue, 18 January 2022 00:44
		Re: Zeta 2 and ParPortProp By: alkmar on Tue, 18 January 2022 23:18
		Re: Zeta 2 and ParPortProp By: alkmar on Tue, 18 January 2022 23:39
		Re: Zeta 2 and ParPortProp By: stefanf on Wed, 19 January 2022 00:32
		Re: Zeta 2 and ParPortProp By: alkmar on Wed, 19 January 2022 19:53
		Re: Zeta 2 and ParPortProp By: stefanf on Thu, 20 January 2022 02:16
		Re: Zeta 2 and ParPortProp By: alkmar on Thu, 20 January 2022 10:24
		Re: Zeta 2 and ParPortProp By: stefanf on Fri, 21 January 2022 01:09

Previous Topic:	Debugging a SBC V2-004
Next Topic:	Dave (Yoda) Mehaffy's passing

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 06:12:07 PDT 2025

Total time taken to generate the page: 0.19742 seconds