RetroBrew Computers Forum: General Discussion

Home » RBC Forums » General Discussion » Zeta 2 and ParPortProp

Show: Today's Messages :: Show Polls :: Message Navigator

Re: Zeta 2 and ParPortProp [message #9635 is a reply to message #9631]

Tue, 18 January 2022 23:18

alkmar
Messages: 29
Registered: August 2019

Junior Member

I ran a ground on that too. it turned out to be the revision of firmware I programmed the ParaPort with. If I remember correctly their is a directory buried with thin the Zeta 2 distro that includes new firmware for the ParaPort. I'll take a look tomorrow and get back to you.

my symptoms were my Zeta 2 worked in every way except for it not seeing the ParaPort, the Paraport VGA output worked perfectly without getting text from the Zeta 2, and you would get the initial beep from the ParaPort pizo speaker.

Report message to a moderator

[Message index]

		Zeta 2 and ParPortProp By: stefanf on Tue, 18 January 2022 00:44
		Re: Zeta 2 and ParPortProp By: alkmar on Tue, 18 January 2022 23:18
		Re: Zeta 2 and ParPortProp By: alkmar on Tue, 18 January 2022 23:39
		Re: Zeta 2 and ParPortProp By: stefanf on Wed, 19 January 2022 00:32
		Re: Zeta 2 and ParPortProp By: alkmar on Wed, 19 January 2022 19:53
		Re: Zeta 2 and ParPortProp By: stefanf on Thu, 20 January 2022 02:16
		Re: Zeta 2 and ParPortProp By: alkmar on Thu, 20 January 2022 10:24
		Re: Zeta 2 and ParPortProp By: stefanf on Fri, 21 January 2022 01:09

Previous Topic:	Debugging a SBC V2-004
Next Topic:	Dave (Yoda) Mehaffy's passing

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Oct 12 04:16:38 PDT 2025

Total time taken to generate the page: 0.10170 seconds