RetroBrew Computers Forum
Discussion forum for the RetroBrew Computers community.

Home » RBC Forums » General Discussion » A simple CP/M Z80 SBC without glue logic
Re: A simple CP/M Z80 SBC without glue logic [message #6218 is a reply to message #6217] Thu, 04 April 2019 14:42 Go to previous messageGo to previous message
wsm is currently offline  wsm
Messages: 232
Registered: February 2017
Location: AB, Canada
Senior Member
I agree that some of us are going back to our roots and the Z80 ... it's fun to be able to fully understand all the hardware and software. My "someday" list still includes a small Z84C15 system ... basically the Z80 + KIO at 16MHz. Utsource lists the Z84C1516 (QFP100) for about $5 but the Z84C13 (basically the same but without PIO) was in PLCC84 form factor. Then again, I already have too many projects on the go!
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: SDC_68k
Next Topic: Question ISA BUS clock


Current Time: Sat Sep 27 21:35:22 PDT 2025

Total time taken to generate the page: 0.09762 seconds