RetroBrew Computers Forum
Discussion forum for the RetroBrew Computers community.

Home » RBC Forums » General Discussion » General Instrument CTS256A-AL2 vs. Microchip CTS256AL2
Re: Is the PIC/TMS7041 field programmable? [message #10341 is a reply to message #10340] Mon, 08 May 2023 12:50 Go to previous messageGo to previous message
lynchaj is currently offline  lynchaj
Messages: 1080
Registered: June 2016
Senior Member
Hi
I just had a realization that the existence of the SE70P161 "prototyping device" with the piggyback EPROM highly suggests the TMS7041 is mask programmed. You can see there are several variants of the TMS7041 available on the market but they all have -xxx suffixes which further suggest they are mask programmed. So if you want to prototype a TMS7041 you need the SE70P161 to change the contents of the onboard ROM. Which sucks because likely there is no such thing as a "blank" TMS7041 and SE70P161s are even more scarce than PIC7041/TMS7041s.

Although it does suggest if one were to obtain an SE70P161, it could be programmed to emulate a CTS256A-AL2. Probably cheaper and easier to pay the highway robbery prices on eBay for the genuine article CTS256A-AL2 though unless a miracle occurs. Fortunately, I have a CTS256A-AL2 left over from earlier days. I'll be sure to hold on to that one

Thanks, Andrew Lynch
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Dave Runkle's front panel for the SBC6120-RBC
Next Topic: Resurrecting EaZy80, a forgotten glue-less 22MHz Z80 SBC.


Current Time: Fri Sep 26 19:58:33 PDT 2025

Total time taken to generate the page: 0.00840 seconds