RetroBrew Computers Forum: General Discussion

Home » RBC Forums » General Discussion » Zeta 2 and ParPortProp

Show: Today's Messages :: Show Polls :: Message Navigator

Re: Zeta 2 and ParPortProp [message #9640 is a reply to message #9638]

Thu, 20 January 2022 02:16

stefanf
Messages: 4
Registered: October 2021

Junior Member

Hi there,

when switching on there is a beep, the LED of the SD card slot lights up briefly, the following appears on the monitor:

Initializing ParPortProb .... OK
Initializing KeyBoard....OK
Initializing SD card ..... OK
Initializing Serial Port ... OK
Starting PortIO cog..... OK
ParPortProp is ready!

At the bottom of the screen appears:

RomWBW ParPortProp F/W v0.96

After that there is a break and it doesn't go any further

greeting

Stefan

Report message to a moderator

[Message index]

		Zeta 2 and ParPortProp By: stefanf on Tue, 18 January 2022 00:44
		Re: Zeta 2 and ParPortProp By: alkmar on Tue, 18 January 2022 23:18
		Re: Zeta 2 and ParPortProp By: alkmar on Tue, 18 January 2022 23:39
		Re: Zeta 2 and ParPortProp By: stefanf on Wed, 19 January 2022 00:32
		Re: Zeta 2 and ParPortProp By: alkmar on Wed, 19 January 2022 19:53
		Re: Zeta 2 and ParPortProp By: stefanf on Thu, 20 January 2022 02:16
		Re: Zeta 2 and ParPortProp By: alkmar on Thu, 20 January 2022 10:24
		Re: Zeta 2 and ParPortProp By: stefanf on Fri, 21 January 2022 01:09

Previous Topic:	Debugging a SBC V2-004
Next Topic:	Dave (Yoda) Mehaffy's passing

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 10:11:40 PDT 2025

Total time taken to generate the page: 0.00768 seconds