RetroBrew Computers Forum: General Discussion

Home » RBC Forums » General Discussion » Zeta 2 and ParPortProp

Show: Today's Messages :: Show Polls :: Message Navigator

Zeta 2 and ParPortProp [message #9631]

Tue, 18 January 2022 00:44

stefanf
Messages: 4
Registered: October 2021

Junior Member

Hi there,

I've built the Zeta 2 and the ParPortProb board and both are working so far. But if I connect both with each other, the PartPortProb Board is not recognized, see picture.
I programmed the 24LC512 EEprom as in the instructions and adopted the standard templates.
Can someone help? thank you

Kind regards

Stefan F, Germany/Berlin

Attachment: Startmeldung.JPG
(Size: 37.04KB, Downloaded 238 times)

Report message to a moderator

[Message index]

		Zeta 2 and ParPortProp By: stefanf on Tue, 18 January 2022 00:44
		Re: Zeta 2 and ParPortProp By: alkmar on Tue, 18 January 2022 23:18
		Re: Zeta 2 and ParPortProp By: alkmar on Tue, 18 January 2022 23:39
		Re: Zeta 2 and ParPortProp By: stefanf on Wed, 19 January 2022 00:32
		Re: Zeta 2 and ParPortProp By: alkmar on Wed, 19 January 2022 19:53
		Re: Zeta 2 and ParPortProp By: stefanf on Thu, 20 January 2022 02:16
		Re: Zeta 2 and ParPortProp By: alkmar on Thu, 20 January 2022 10:24
		Re: Zeta 2 and ParPortProp By: stefanf on Fri, 21 January 2022 01:09

Previous Topic:	Debugging a SBC V2-004
Next Topic:	Dave (Yoda) Mehaffy's passing

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 03:32:31 PDT 2025

Total time taken to generate the page: 0.00756 seconds