RetroBrew Computers Forum: General Discussion » ROM-less 6502-based EPROM programmer

Home » RBC Forums » General Discussion » ROM-less 6502-based EPROM programmer

Show: Today's Messages :: Show Polls :: Message Navigator

ROM-less 6502-based EPROM programmer [message #9421]

Thu, 25 November 2021 07:15

plasmo
Messages: 916
Registered: March 2017
Location: New Mexico, USA

Senior Member

I have been working on a ROM-less 6502-based EPROM programmer on 6502.org that has reached some level of success. The discussion about that project is here: http://forum.6502.org/viewtopic.php?f=4&t=6841

I'm documenting the design on retrobrewcomputers here:
https://www.retrobrewcomputers.org/doku.php?id=builderpages: plasmo:6502:prog65

My plan is revise the current pc board and release design files to public domain so anyone can build it. I will have limited number of spare pc boards to give away in few weeks.
Bill
/forum/index.php?t=getfile&id=2499&private=0

/forum/index.php?t=getfile&id=2499&private=0

Attachment: DSC_66851124_F.jpg
(Size: 247.42KB, Downloaded 454 times)

Report message to a moderator

Re: ROM-less 6502-based EPROM programmer [message #9634 is a reply to message #9421]

Tue, 18 January 2022 21:05

plasmo
Messages: 916
Registered: March 2017
Location: New Mexico, USA

Senior Member

This is the pc board version of Prog65. It has a different homepage at:
https://www.retrobrewcomputers.org/doku.php?id=builderpages: plasmo:6502:prog65:prog65r2:prog65r2home

Currently it can program SST39SF010 and SST39SF040. With a different program it should be able to program AT49F040. With an engineering change it can also program AT28C256. It is not meant to be a general purpose programmer; the ability to program the inexpensive SST39SF010/040 is really the intent of this hardware.

It has two mode of operation; with the switch "up" it is an EPROM programmer; with the switch "down" it will boot from the newly programmed EPROM. The screen capture shows a simple 4-function monitor that was programmed in the program mode and executing in normal mode.

This 4"x4" 2-layer board fits in the PacTec CM5-125 enclosure.
/forum/index.php?t=getfile&id=2621&private=0

/forum/index.php?t=getfile&id=2621&private=0

/forum/index.php?t=getfile&id=2622&private=0

Attachment: Prog65_rev1_f.jpg
(Size: 440.17KB, Downloaded 336 times)
Attachment: Prog65_monitor.jpg
(Size: 64.82KB, Downloaded 323 times)

Report message to a moderator

Previous Topic:	Zero Glue logic 6502 SBC
Next Topic:	Debugging a SBC V2-004

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Oct 12 14:37:00 PDT 2025

Total time taken to generate the page: 0.00796 seconds