| Netlist auditing question [message #10831] |
Sun, 11 August 2024 10:34  |
 |
rcini
Messages: 64
Registered: October 2015
Location: Long Island, NY
|
Member |
|
|
All --
This question isn't specific to a particular Retrobrew project, but after having done many successful ECB boards, I'm bedeviled by a reproduction S100 board I'm working on and at this point I think I need to do a net-by-net comparison of the prototype to the reproduction. Because I started this project over a year ago, I'm on KiCAD 6. KiCAD has the ability to export a netlist, but it's really not user friendly. What I need is a very easy listing of each device pin and where it connects so I can ohm-out the board and check it off as I go.
For perspective, it's a very dense board -- 4 layer with 67 ICs -- and it has a bunch of manual ECOs on it. If anyone has a particular solution for this, I'd like to hear about it.
Thanks!
Rich
Rich Cini
|
|
|
|
RetroBrew Computers Forum
Members
Search
Help
Login
Home
