Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
builderpages:plasmo:z280rc:new_cfdisk [2018/06/09 23:46] plasmo |
builderpages:plasmo:z280rc:new_cfdisk [2018/06/10 13:13] plasmo |
||
---|---|---|---|
Line 7: | Line 7: | ||
**Enable the UART Bootstrap mode by removing the Mode jumper.\\ | **Enable the UART Bootstrap mode by removing the Mode jumper.\\ | ||
- | Upload | + | Send '{{: |
// | // | ||
Line 37: | Line 37: | ||
===== Load files in CF Bootstrap mode ===== | ===== Load files in CF Bootstrap mode ===== | ||
- | **Enable the CF bootstrap mode and reset.** | + | **Enable the CF bootstrap mode and reset. It is not necessary to add line transmission delay to the serial port communication in the following.** |
==== Install CP/M2.2 ==== | ==== Install CP/M2.2 ==== | ||
- | **Load cpm22all.hex before issuing ' | + | **Load |
//TinyZZ Monitor v0.99 6/9/18// | //TinyZZ Monitor v0.99 6/9/18// | ||
Line 55: | Line 55: | ||
==== Install CP/M 3 ==== | ==== Install CP/M 3 ==== | ||
- | **Load cpmldr.hex before issuing ' | + | **Load |
//> | //> | ||
Line 66: | Line 66: | ||
2–CP/ | 2–CP/ | ||
3–CP/M3: //**3**// press Return to execute command// | 3–CP/M3: //**3**// press Return to execute command// | ||
- | ==== Install CP/M22 distribution files ==== | + | ==== Install |
**Clear drives A/B/C/D before loading CPM distribution files** | **Clear drives A/B/C/D before loading CPM distribution files** | ||
Line 98: | Line 98: | ||
E – RAM drive: //**D**// press Return to execute command// | E – RAM drive: //**D**// press Return to execute command// | ||
- | **load cpm22dri.hex, | + | **load |
//> | //> | ||
Line 143: | Line 143: | ||
==== Install CP/M 3 distribution files ==== | ==== Install CP/M 3 distribution files ==== | ||
- | **Load the CPM3 distribution files.\\ | + | **Load the CPM3 distribution files, {{: |
- | It is a big file, taking | + | It is a big file, taking |
// | // |