[[builderpages:gary_kaufman:z80ice]]
You are here: start » builderpages » gary_kaufman » z80ice
Show page
AdminRecent ChangesSitemap

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
builderpages:gary_kaufman:z80ice [2016/03/09 11:52]
gkaufman 		builderpages:gary_kaufman:z80ice [2016/03/09 11:53] (current)
gkaufman
Line 15: Line 15:
 Please also read and review all of the notes on the Tauntek site [[http://tauntek.com/Z80-In-Circuit-Emulator.htm|http://tauntek.com/Z80-In-Circuit-Emulator.htm]]. Please also read and review all of the notes on the Tauntek site [[http://tauntek.com/Z80-In-Circuit-Emulator.htm|http://tauntek.com/Z80-In-Circuit-Emulator.htm]].
  
-The CPLD and PIC are pre-programmed.  Make sure you watch the orientation (all IC's are not in the same orientation).+The CPLD and PIC are pre-programmed.  Make sure you watch the orientation (all IC's do not mount in the same direction).
  
 Cut the board along the silk screen line before any construction. I used a band saw, but carefully scoring with a sharp blade should also work. Cut the board along the silk screen line before any construction. I used a band saw, but carefully scoring with a sharp blade should also work.
builderpages/gary_kaufman/z80ice.1457542355.txt.gz · Last modified: 2016/03/09 11:52 by gkaufman
Show pageOld revisions
Media ManagerBack to top
Driven by DokuWiki Recent changes RSS feed Valid CSS Valid XHTML 1.0