Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
boards:ecb:vdu:start [2019/03/04 08:00]
b1ackmai1er [Jumpers]
boards:ecb:vdu:start [2019/03/15 09:46] (current)
b1ackmai1er [Input/output connectors]
Line 127: Line 127:
 ====== Input/​output connectors ====== ====== Input/​output connectors ======
  
-<​note>​There isn't a RESET select jumper on this board. RESET is configured for LEGACY mode. To run in KONTRON mode the trace from pin 15 IC26 (74LS241) to ECB connector ​C29 should be cut and pin 15 IC26 should be connected to ECB connector C26</​note>​+<​note>​There isn't a RESET select jumper on this board. RESET is configured for LEGACY mode. To run in KONTRON mode the trace from pin 15 IC26 (74LS241) to ECB connector ​C31 should be cut and pin 15 IC26 should be connected to ECB connector C26</​note>​
  
   * P3 - Parallel printer.   * P3 - Parallel printer.
Line 133: Line 133:
   * P5 - PS/2 mouse.   * P5 - PS/2 mouse.
   * K3 - Light pen input.   * K3 - Light pen input.
- 
-\\ 
  
  
boards/ecb/vdu/start.txt · Last modified: 2019/03/15 09:46 by b1ackmai1er
Driven by DokuWiki Recent changes RSS feed Valid CSS Valid XHTML 1.0